Command Line Reference Guide

Version Description
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
This command enables the IGMP switch to send General Queries periodically. This
behavior is useful when there is no multicast router present in the VLAN because
the multicast traffic is not routed. Assign an IP address to the VLAN interface for the
switch to act as a querier for this VLAN.
show ip igmp snooping mrouter
Display multicast router interfaces.
Z9500
Syntax
show ip igmp snooping mrouter [vlan number]
Parameters
vlan number Enter the keyword vlan then the vlan number. The range is
from 1 to 4094.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
If the port channel is a VLT port channel, an asterisk (*) after the port channel
number (Po 100*) indicates the port channel is locally down and that a remote VLT
port is up.
Example
Dell#show ip igmp snooping mrouter
Interface Router Ports
Internet Group Management Protocol (IGMP)
699