Command Line Reference Guide

Version Description
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
show ip igmp groups
View the IGMP groups.
Z9500
Syntax
show ip igmp groups [group-address [detail] | detail |
interface [group-address [detail]]]
Parameters
group-address (OPTIONAL) Enter the group address in dotted decimal
format to view information on that group only.
interface (OPTIONAL) Enter the interface type and slot/port
information:
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface enter the keyword vlan then a
number from 1 to 4094.
detail (OPTIONAL) Enter the keyword detail to display the
IGMPv3 source information.
Command
Modes
• EXEC
• EXEC Privilege
Internet Group Management Protocol (IGMP)
689