Command Line Reference Guide

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the S-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
7.5.1.0 Introduced on the C-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
ip igmp query-max-resp-time
Set the maximum query response time advertised in general queries.
Z9500
Syntax
ip igmp query-max-resp-time seconds
To return to the default values, use the no ip igmp query-max-resp-time
command.
Parameters
seconds Enter the number of seconds for the maximum response
time. The range is from 1 to 25. The default is 10 seconds.
Defaults 10 seconds
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
Internet Group Management Protocol (IGMP)
685