Command Line Reference Guide

ip igmp immediate-leave
Enable IGMP immediate leave.
Z9500
Syntax
ip igmp immediate-leave [group-list prefix-list-name]
To disable ip igmp immediate leave, use the no ip igmp immediate-
leave command.
Parameters
group-list
prefix-list-
name
Enter the keywords group-list then a string up to 16
characters long of the prefix-list-name.
Defaults Not configured.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
Querier normally sends some group-specific queries when a leave message is
received for a group prior to deleting a group from the membership database.
There may be situations when you require immediate deletion of a group from the
membership database. This command provides a way to achieve the immediate
deletion. In addition, this command provides a way to enable immediate-leave
processing
for specified groups.
682
Internet Group Management Protocol (IGMP)