Command Line Reference Guide

• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults Disabled.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
IGMP commands accept only non-VLAN interfaces — specifying VLAN does not
yield results. This command displays packets for IGMP and IGMP snooping.
ip igmp access-group
To specify access control for packets, use this feature.
Z9500
Syntax
ip igmp access-group access-list
To remove the feature, use the no ip igmp access-group access-list
command.
Parameters
access-list Enter the name of the extended ACL (16 characters
maximum).
Defaults Not configured
Command
Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
680
Internet Group Management Protocol (IGMP)