Command Line Reference Guide

• Leave All Timer — The Leave All timer starts when a GARP application entity
starts. When this timer expires, the entity sends a Leave-all message so that
other entities can reregister their attribute information. Then the
Leave-all
time begins again.
Related
Commands
show garp timers — displays the current GARP times.
gvrp enable
Enable GVRP on physical interfaces and LAGs.
Z9500
Syntax
gvrp enable
To disable GVRP on the interface, use the no gvrp enable command.
Defaults Disabled.
Command
Modes
CONFIGURATION-INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on C-Series, E-Series, and S-Series
Related
Commands
disable — globally disables GVRP.
GARP VLAN Registration (GVRP)
671