Command Line Reference Guide

To negate a command, use the no ip ecmp-group maximum-paths {number}
command.
Parameters
maximum-
paths
Specify the maximum number of ECMP for a route. The
range is 2 to 64.
path-fallback Use the keywords path-fallback to enable this feature. If
you enable the feature, re-enter this keyword to disable the
feature.
Defaults 16
Command
Modes
CONFIGURATION
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
Usage
Information
You must save the new ECMP settings to the startup-config (write-mem) then
reload the system for the new settings to take effect.
Related
Commands
show ip cam linecard – Display content-addressable memory (CAM) entries for a
set of ports on a line card.
link-bundle-distribution trigger-threshold
Provides a mechanism to set the threshold to trigger when traffic distribution begins being monitored on
an ECMP link bundle.
Z9500
Syntax
link-bundle-distribution trigger-threshold [percent]
To exit from ecmp group mode, use the exit command.
Parameters
percent Indicate the threshold value when traffic distribution starts
being monitored on an ECMP link bundle. The range is from
1 to 90%. The default is 60%.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
Equal Cost Multi-Path (ECMP)
645