Command Line Reference Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the E-Series.
8.2.1.0 Added the keyword ipmac.
7.8.1.0 Introduced on the C-Series and S-Series.
Usage
Information
Allocate at least one FP block to ipmacacl before you can enable IP+MAC Source
Address Validation.
1. Use the cam-acl l2acl command from CONFIGURATION mode.
2. Save the running-config to the startup-config.
3. Reload the system.
show ip dhcp binding
Display the DHCP binding table.
Z9500
Syntax
show ip dhcp binding
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
634
Dynamic Host Configuration Protocol (DHCP)