Command Line Reference Guide

slice=1, slice_idx=0x1, part =1 prio=0x130d,
flags=0x10204, Installed, Enabled
tcam: color_indep=0,
IpType
Offset: 208 Width: 5
DATA=0x00000004
MASK=0x0000000c
L3Routable
Offset: 166 Width: 1
DATA=0x00000001
MASK=0x00000001
OutPort
Offset: 195 Width: 7
DATA=0x00000001
MASK=0x0000007f
action={act=Drop, param0=0(0), param1=0(0),
param2=0(0), param3=0(0)}
policer=
statistics={stat id 110 slice = 0 idx=4 entries=1}
{Packets}
Usage
Information
The port-set values are internal port numbers. For a cross reference of the internal
and port numbers, refer to the Debugging and Diagnostics chapter in the Dell
Networking OS Configuration Guide for the Z9500 System.
show hardware layer2
Display information about the Layer 2 ACLs used on a Z9500 line card and port pipe.
Z9500
Syntax
show hardware layer2 {eg-acl | in-acl} linecard slot-id port-
set number
Parameters
eg-acl | in-acl Enter either the keyword eg-acl or the keyword in-acl to
display ingress or egress ACL data.
linecardslot-id Enter the linecard slot-id parameters to specify a
Z9500 line card. The range of slot IDs is from 0 to 2.
port-set
number
Enter the keywords port-set number parameters to
specify a port pipe (set of ports) on a line card. The range of
port-set numbers is from 0 to 3.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Debugging and Diagnostics
599