Command Line Reference Guide

Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
Related
Commands
show hardware — displays the data plane or management plane input and output
statistics for a specified hardware component.
remote-exec
Debug and troubleshoot switch hardware using remote commands.
WARNING: Use the remote-exec command only with the guidance of an engineer from Dell
Networking Technical Support.
Z9500
Syntax
remote-exec {cp | rp | linecard slot-id} hw-command
Parameters
cp Enter the keyword cp to troubleshoot Control Processor
CPU operation.
rp Enter the keyword rp to troubleshoot Route Processor CPU
operation.
linecard slot-id Enter the linecard slot-id to troubleshoot line-card
CPU operation. The range of line-card slot IDs is from 0 to 2.
Each line-card CPU processes packets on the corresponding
Z9500 line card.
hw-command Enter the debug command that Dell Networking Tech
Support gives you.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
Debugging and Diagnostics
581