Command Line Reference Guide

VRRP Mode

To enable and configure Virtual Router Redundancy Protocol (VRRP), use VRRP mode. For more

information, refer to Virtual Router Redundancy Protocol (VRRP).

To enter VRRP mode:

1. To enable VRRP globally, verify that you are logged in to CONFIGURATION mode.

2. Enter the vrrp-group command then enter the VRRP group ID. The prompt changes to include

(conf-if-interface-type-slot/port-vrid-vrrp-group-id).

UPLINK STATE GROUP Mode

To enable and configure an uplink-state group, use UPLINK STATE GROUP mode. For more information,

refer to Uplink Failure Detection (UFD).

To enter UPLINK STATE GROUP mode:

1. Verify that you are logged in to CONFIGURATION mode.

2. Enter the uplink-state-group command then the group ID number. The prompt changes to

include (conf-uplink-state-group-

groupID).

CLI Basics