Command Line Reference Guide

Version Description
9.5(0.1) Introduced on the Z9500.
9.2(0.2) Changed the default value from global 4q to Dynamic.
8.3.19.0 Introduced on the S4820T.
8.3.11.0 Introduced on the Z9000.
7.8.1.0 Added the global keyword.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
Usage
Information
The buffer-profile global command fails if you have already applied a
custom buffer-profile on an interface. Similarly, when you configure buffer-
profile global, you cannot not apply buffer-profile on any interface.
If the default buffer-profile is active, Dell Networking OS displays an error message
instructing you to remove the default configuration using the no buffer-
profile global command.
Reload the system for the global buffer-profile to take effect.
Hardware Commands
The hardware commands supported on the switch allow you to display information from a hardware
sub-component or ASIC.
clear control-traffic
Clear control-traffic statistics from a Z9500 CPU.
Z9500
Syntax
clear control—traffic {all | cp—switch | linecard slot-id
portset port-pipe} counters
Parameters
cp-switch Enter the keyword cp-switch to clear the counters for
control traffic on the control plane.
linecard slot-id
portset port-
pipe
Enter the slot ID and port pipe to clear the counters for
control traffic on a specified Z9500 line card and port set.
The range of Z9500 slot IDs is from 0 to 2. The range of
port-pipe numbers is: 0 to 2 on line card 0 and 0 to 3 on line
cards 1 and 2.
all Enter the keyword all to clear control-traffic statistics on
the control plane and all line cards.
Debugging and Diagnostics
577