Command Line Reference Guide

NO NO NO
qsfpReadInterruptTest: ALL RUN NO NO
NO NO YES
qsfpReadModeTest: ALL RUN NO NO
NO NO YES
rtcTest: ALL RUN YES YES
NO NO NO
sataSsdTest: ALL RUN YES YES
NO NO NO
temperatureTest: ALL RUN YES NO
NO NO NO
Buffer Tuning Commands
This section describes the buffer tuning commands supported on the switch.
WARNING: Reconfiguring the buffer allocations is a sensitive operation. Do not use any buffer
tuning command without first contacting the Dell Networking Technical Assistance Center (TAC).
buffer-profile (Configuration)
Create a buffer profile that can be applied to an interface.
Z9500
Syntax
buffer-profile {fp | csf] profile-name {global {1Q | | 4q}
Parameters
fp Enter the keyword fp to create a buffer profile for the Field
Processor.
csf Enter the keyword csf to create a buffer profile for the
Switch Fabric Processor.
profile-name Create a name for the buffer profile,
global Apply one of two pre-defined buffer profiles to all of the
port-pipes in the system.
1Q Enter the keyword 1Q to choose a pre-defined buffer profile
for single queue (for example, non-QoS) applications.
4Q Enter the keyword 4q to choose a pre-defined buffer profile
for four queue (for example, QoS) applications.
Defaults Dynamic
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
576
Debugging and Diagnostics