Command Line Reference Guide

router bgp
Enter ROUTER BGP mode to configure and enable BGP.
Z9500
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
process-id Enter the number of the OSPFv3 process. The range is 1 to
65535.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
show capture bgp-pdu neighbor
Display BGP packet capture information for an IPv6 address.
Z9500
Syntax
show capture bgp-pdu neighbor ipv6-address
Parameters
ipv6-address Enter the IPv6 address (X:X:X:X::X) of a BGP neighbor.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced
Related
Commands
• capture bgp-pdu neighbor – enables capture of an IPv6 BGP neighbor packet.
• clear ip bgp – specifies a size for the capture buffer.
522
Border Gateway Protocol