Command Line Reference Guide

Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage
Information
Applies to EBGP neighbors only.
If the AS-PATH contains both public and private AS number or contains AS
numbers of an EBGP neighbor, the private AS numbers are not removed.
If a confederation contains private AS numbers in its AS-PATH, the software
removes the private AS numbers only if they follow the confederation numbers in
the AS path.
Private AS numbers are 64512 to 65535.
neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
Z9500
Syntax
neighbor {ipv6-address | peer-group-name} route-map map-name
{in | out}
To remove the route map, use the no neighbor {ipv6-address | peer-
group-name
} route-map map-name {in | out} command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group.
map-name Enter the name of an established route map. If you do not
configure the Route map, the default is deny (to drop all
routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
Defaults Not configured.
510
Border Gateway Protocol