Command Line Reference Guide

Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group to enter the remote AS
into routing tables of all routers within the peer group.
number Enter a number of the AS. The range is 1 to 65535.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage
Information
If the number parameter is the same as the AS number used in the router bgp
command, the remote AS entry in the neighbor is considered an internal BGP peer
entry.
This command creates a peer and the newly created peer is disabled (shutdown).
Related
Commands
router bgp – Enter ROUTER BGP mode and configure routes in an AS.
neighbor remove-private-as
Remove private AS numbers from the AS-PATH of outgoing updates.
Z9500
Syntax
neighbor {ipv6-address | peer-group-name} remove-private-as
To return to the default, use the no neighbor {ipv6-address | peer-
group-name} remove-private-as command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group to remove the private AS
numbers.
Defaults Disabled (that is, private AS number are not removed).
Border Gateway Protocol
509