Command Line Reference Guide

• neighbor advertisement-interval
• neighbor distribute-list
• neighbor route-map
• neighbor route-reflector-client
• neighbor send-community
A neighbor may keep its configuration after it was added to a peer group if the
neighbor’s configuration is more specific than the peer group’s, and the neighbor’s
configuration does not affect outgoing updates.
A peer group must exist before you add a peer to it. If the peer group is disabled
(shutdown), the peers within the group are also disabled (shutdown).
Related
Commands
• clear ip bgp – resets BGP sessions.
• neighbor peer-group (creating group) – creates a peer group.
• show ip bgp peer-group – view BGP peers.
• show ip bgp neighborsshow ip bgp neighbors View BGP neighbors
configurations.
neighbor peer-group (creating group)
Allows you to create a peer group and assign it a name.
Z9500
Syntax
neighbor peer-group-name peer-group
To delete a peer group, use the no neighbor peer-group-name peer-group
command.
Parameters
peer-group-
name
Enter a text string up to 16 characters long as the name of
the peer group.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage
Information
When a peer group is created, it is disabled (shut mode).
Border Gateway Protocol
507