Command Line Reference Guide

Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage
Information
If you configure the set ipv6 next-hop command in ROUTE-MAP mode, its
configuration takes precedence over the neighbor next-hop-self command.
neighbor peer-group (assigning peers)
Allows you to assign one peer to a existing peer group.
Z9500
Syntax
neighbor ipv6-address peer-group peer-group-name
To delete a peer from a peer group, use the no neighbor ipv6-address
peer-group peer-group-name command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group
peer-group-
name
Enter the keywords peer-group followed by the name of a
configured peer group. The maximum is 16 characters.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage
Information
You can assign up to 64 peers to one peer group.
When you add a peer to a peer group, it inherits all the peer group’s configured
parameters. A peer cannot become part of a peer group if any of the following
commands are configured on the peer:
506
Border Gateway Protocol