Command Line Reference Guide

this percentage of the maximum value, the software sends a
message. The range is 1 to 100 percent. The default is 75.
warning-only (OPTIONAL) Enter the keywords warning-only to set the
router to send a log message when the maximum value is
reached. If you do not set this parameter, the router stops
peering when the maximum number of prefixes is reached.
Defaults threshold = 75
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage
Information
If you configure the neighbor maximum-prefix command and the neighbor
receives more prefixes than allowed by the neighbor maximum-prefix
command configuration, the neighbor goes down and the show ip bgp
summary command displays (prfxd) in the State/PfxRcd column for that neighbor.
The neighbor remains down until you enter the clear ip bgp command for the
neighbor or the peer group to which the neighbor belongs or you enter the
neighbor shutdown and neighbor no shutdown commands.
Related
Commands
show ip bgp summary – displays the current BGP configuration.
neighbor next-hop-self
Allows you to configure the router as the next hop for a BGP neighbor. (This command is used for IBGP).
Z9500
Syntax
neighbor {ipv6-address | peer-group-name} next-hop-self
To return to the default setting, use the no neighbor {ipv6-address | peer-
group-name
} next-hop-self command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
(OPTIONAL) Enter the name of the peer group.
Defaults Disabled.
Border Gateway Protocol
505