Command Line Reference Guide

Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group to apply the filter to all
routers in the peer group.
as-path-name Enter the name of an established AS-PATH access list. If you
do not configure the AS-PATH access list, the default is
permit (to allow routes). The maximum is 16 characters.
in Enter the keyword in to filter inbound BGP routes.
out Enter the keyword out to filter outbound BGP routes.
Defaults Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
neighbor maximum-prefix
Control the number of network prefixes received.
Z9500
Syntax
neighbor {ipv6-address | peer-group-name} maximum-prefix
maximum [threshold] [warning-only]
To return to the default values, use the no neighbor {ipv6-address | peer-
group-name} maximum-prefix maximum [threshold] [warning-only]
command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group.
maximum Enter a number as the maximum number of prefixes allowed
for this BGP router. The range is 1 to 4294967295.
threshold (OPTIONAL) Enter a number to be used as a percentage of
the maximum value. When the number of prefixes reaches
504
Border Gateway Protocol