Command Line Reference Guide

Parameters
ipv6-address Enter an IPv6 address to reset neighbors belonging to that IP.
Used without a qualifier, the keyword resets all neighbors
belonging to that IP.
flap-statistics (OPTIONAL) Enter the keywords flap-statistics to clear
all flap statistics belonging to that AS or a specified address
family within that IP.
ipv4 (OPTIONAL) Enter the keyword ipv4 to select options for
that address family.
ipv6 (OPTIONAL) Enter the keyword ipv6 to select options for
that address family.
unicast (OPTIONAL) Enter the keyword unicast to select the
unicast option within the selected address family.
multicast (OPTIONAL) Enter the keyword multicast to select the
multicast option within the selected address family. Multicast
is supported on IPv4 only
soft (OPTIONAL) Enter the keyword soft to configure and
activate policies without resetting the BGP TCP session, that
is, BGP Soft Reconfiguration.
NOTE: If you enter clear ip bgp ip6-address
soft
, both inbound and outbound policies are reset.
in (OPTIONAL) Enter the keyword in to activate only inbound
policies.
out (OPTIONAL) Enter the keyword out to activate only
outbound policies.
Command
Modes
EXEC Privilege
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
clear ip bgp * (asterisk)
Reset all BGP sessions in the specified category. The soft parameter (BGP Soft Reconfiguration) clears the
policies without resetting the TCP connection.
Z9500
Syntax
clear ip bgp * [ipv4 multicast soft [in | out] | ipv6 unicast
soft [in | out] | soft [in | out]]
Border Gateway Protocol
483