Command Line Reference Guide

Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
The system supports one ingress and one egress MAC ACL per interface.
The number of entries allowed per ACL is hardware-dependent. For detailed
information on the number entries allowed per ACL on the Z9500, refer to the
Content Addressable Memory (CAM) chapter in the Z9500 Configuration Guide.
Example
Dell(conf)#mac-access-list access-list standard TestMAC
Dell(config-std-macl)#?
deny Specify packets to reject
description List description
exit Exit from access-list configuration mode
no Negate a command or set its defaults
permit Specify packets to forward
remark Specify access-list entry remark
seq Sequence numbers
show Show Standard ACL configuration
permit
To forward packets from a specific source MAC address, configure a filter.
Z9500
Syntax
permit {any | mac-source-address [mac-source-address-mask]}
[count [byte]] | [log [interval minutes] [threshold-in-msgs
[count]] [monitor]
Access Control Lists (ACL)
267