Command Line Reference Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to version 7.8.1.0, names are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for the non-contiguous mask and added the
monitor option.
6.5.1.0 Expanded to include the optional QoS order priority for the
ACL entry.
Usage
Information
The system supports one ingress and one egress IP ACL per interface.
The number of entries allowed per ACL is hardware-dependent. For detailed
information on the number entries allowed per ACL on the Z9500, refer to the
Content Addressable Memory (CAM) chapter in the Z9500 Configuration Guide.
Example
Dell(conf)#ip access-list standard TestList
Dell(config-std-nacl)#
Related
Commands
ip access-list extended — creates an extended access list.
show config — displays the current configuration.
permit
Configure a filter to permit packets from a specific source IP address to be processed and forwarded to
another interface on the switch.
Z9500
Syntax
permit {source [mask]| any | host ip-address}[count [byte]]
[dscp value] [order] [fragments] [log [interval minutes]
[threshold-in-msgs [count]] [monitor]
Access Control Lists (ACL)
211