Command Line Reference Guide

Version Description
6.5.1.0 Expanded to include the optional QoS order priority for the
ACL entry.
Usage
Information
Use the order option only when you use policy-based QoS on the switch. For
more information, refer to the Quality of Service chapter of the Z9500
Configuration Guide.
When you use the log option, the CP processor logs detail the packets that match.
Depending on how many packets match the log entry and at what rate, the CP
may become busy as it has to log these packets’ details.
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is five minutes. By default,
flow-based monitoring is not enabled.
Use the monitor option only when you are using flow-based monitoring. For
more information, refer to the Port Monitoring chapter of the Z9500 Configuration
Guide.
The software cannot count both packets and bytes, so when you enter the count
byte options, only bytes are incremented.
Related
Commands
ip access-list standard — configures a standard ACL.
permit — configures a permit filter.
ip access-list standard
Create a standard IP access list (IP ACL) to filter based on IP address.
Z9500
Syntax
ip access-list standard access-list-name
To delete an access list, use the no ip access-list standard access-
list-name command.
Parameters
access-list-
name
Enter a string up to 140 characters long as the ACL name.
Defaults All IP access lists contain an implicit “deny any”; that is, if no match occurs, the
packet is dropped. ACL permit/deny rules are applied when a packet matches the
condition in an entry.
Command
Modes
CONFIGURATION
210
Access Control Lists (ACL)