Command Line Reference Guide

• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
in | out Identify whether ACL is applied on the ingress or egress side.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for the 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced.
Usage
Information
show ip
accounting
access-lists
Field
Description
“Extended IP...” Displays the name of the IP ACL.
“seq 5...” Displays the filter. If the keywords count or byte were
configured in the filter, the number of packets or bytes the
filter processes is displayed at the end of the line.
“order 4” Displays the QoS order of priority for the ACL entry.
Example
Dell#show ip accounting access FILTER1 interface tengig 1/6
Extended IP access list FILTER1
seq 5 deny ip any 191.1.0.0 /16 count (0x00 packets)
seq 10 deny ip any 191.2.0.0 /16 order 4
seq 15 deny ip any 191.3.0.0 /16
seq 20 deny ip any 191.4.0.0 /16
seq 25 deny ip any 191.5.0.0 /16
Access Control Lists (ACL)
207