Command Line Reference Guide

• on a Layer 3 port or on a Layer 2/Layer 3 port
Related
Commands
ip access-list standard — configures a standard ACL.
ip access-list extended — configures an extended ACL.
ip control-plane egress-filter
Enable egress Layer 3 ACL lookup for IPv4 CPU traffic.
Z9500
Syntax
ip control-plane egress-filter
Defaults Not enabled.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
show ip accounting access-list
Display the IP access-lists created on the switch and the sequence of filters.
Z9500
Syntax
show ip accounting {access-list access-list-name | cam_count}
interface interface
Parameters
access-list-
name
Enter the name of the ACL to be displayed.
cam_count List the count of the CAM rules for this ACL.
interface
interface
Enter the keyword interface then the one of the following
keywords and slot/port or number information:
• For a Port Channel interface, enter the keyword port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
206
Access Control Lists (ACL)