Command Line Reference Guide

{{high | low}
cpu-utilization-
threshold-
percentage}
Enter a percentage value to configure the high or low
threshold level for the percentage of memory a Z9500 CPU
can use. The percentage of memory utilization ranges from
0 to 100.
NOTE: A threshold level of 0 will disable Syslog and
SNMP traps.
Default
• High threshold: 92%
• Low threshold: 82%
Command
Mode
CONFIGURATION
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Example
Dell(conf)# util-threshold memory cp high 75 low 67
Usage
Information
When the total memory utilization for a CPU exceeds the configured high/low
threshold for a given time, a threshold notification is sent as a SNMP trap. If a low
threshold value is not specified, the low threshold value is set to the same value as
the high threshold value.
To return the memory thresholds to the default values, enter the no util-
threshold mem cp | rp | linecard slot—id | all command.
Related
Commands
• show util-threshold memory – Display the configured values of memory
utilization thresholds.
• show util-threshold cpu – Display the configured values of CPU utilization
thresholds.
virtual-ip
Configure a virtual IP address for the active management interface. You can configure virtual addresses
both for IPv4 and IPv6 independently.
Z9500
Syntax
virtual-ip {ipv4-address | ipv6-address}
Control and Monitoring
177