Command Line Reference Guide

Version Description
8.3.7.0 Introduced on the S4810.
Example
Dell(conf)# util-threshold cpu 5sec cp high 50
In this example, the low threshold value is not specified so it will take the value set
for the high threshold value. In all other cases, the low threshold value must be
equal to or less than that of the high threshold value.
Usage
Information
When the total CPU utilization exceeds the configured threshold for the specified
time, a threshold notification is sent as an SNMP trap. If a low threshold value is not
specified, the low threshold value is set to the same value as the high threshold
value. The system will generate a Syslog and SNMP trap each time the configured
CPU threshold is crossed.
NOTE: The 5sec util-threshold cpu command is disabled by default on
all switches. To enable the command, enter util-threshold cpu 5sec
all high {value greater than zero}. To disable the Syslog and traps for the
5sec CPU utilization thresholds, enter
util-threshold cpu 5sec all
high 0 or no util-threshold cpu 5sec {cp | rp | linecard
slot-id | all}.
Related
Commands
• show util-threshold cpu – Display the configured values of CPU utilization
thresholds.
• show util-threshold memory – Display the configured values of memory
utilization thresholds.
util-threshold memory
Configure the high or low memory utilization thresholds for SNMP traps.
Z9500
Syntax
util—threshold memory {cp |rp | linecard slot–id | all} {[high
{0-100}] [low {0-100}]}
Parameters
cp Enter the keyword cp to configure the memory utilization
threshold for the Control Processor CPU.
rp Enter the keyword rp to configure the memory utilization
threshold for the Route Processor CPU.
linecard slot-id Enter the slot ID of the line card for which you want to
configure the memory utilization threshold. The range of
Z9500 slot IDs is from 0 to 2.
all Enter the keyword all to configure the memory utilization
threshold on all Z9500 CPUs: Control Processor, Route
Processor, and line cards.
176
Control and Monitoring