Command Line Reference Guide

Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2.(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series.
Support was added for IPv6 VRRP groups in non-default
VRF instances.
8.3.2.0 Introduced on the E-Series TeraScale.
Usage
Information
If no options are specified, debug is active on all interfaces and all VRRP groups.
show vrrp ipv6
Display the IPv6 VRRP groups that are active. If no VRRP groups are active, the system returns No
Active VRRP group
.
Z9500
Syntax
show vrrp ipv6 [vrid] [interface] [brief]
Parameters
vrid (OPTIONAL) Enter the virtual router identifier for the VRRP
group to view only that group. The range is from 1 to 255.
interface Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the
VLAN ID. The VLAN ID range is from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of
information on the VRRP groups.
1724
Virtual Router Redundancy Protocol (VRRP)