Command Line Reference Guide

State: Master, Priority: 105, Master: 10.1.1.253 (local)
Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Adv sent: 1862, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:01
Virtual IP address:
10.1.1.252
Authentication: (none)
Tracking states for 1 interfaces:
Up TenGigabitEthernet 1/17 priority-cost 10
------------------
TenGigabitEthernet 1/4, VRID: 2, Net: 10.1.2.253
State: Master, Priority: 110, Master: 10.1.2.253 (local)
Hold Down: 10 sec, Preempt: TRUE, AdvInt: 1 sec
Adv rcvd: 0, Adv sent: 1862, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:02
Virtual IP address:
10.1.2.252
Authentication: (none)
Tracking states for 2 interfaces:
Up TenGigabitEthernet 2/1 priority-cost 10
Up TenGigabitEthernet 1/17 priority-cost 10
Dell>
version
Set VRRP protocol version for IPv4 group.
Syntax
version {2 | 3 | both}
To return to the default setting, use the no version command.
Parameters
2 Enter the 2 parameter to specify VRRP version 2 as defined
by RFC 3768,
Virtual Router Redundancy Protocol.
3 Enter the 2 parameter to specify VRRP version 3 as defined
in RFC 5798, Virtual Router Redundancy.
both Enter the both keyword for in-service migration from VRRP
version 2 to VRRP version 3.
Defaults 2
Command
Modes
VRRP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
Virtual Router Redundancy Protocol (VRRP)
1717