Command Line Reference Guide

Defaults Not configured.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810. Added support for source-
interface for link-local IPv6 addressing.
8.3.11.1 Introduced on the Z9000.
8.2.1.0 Introduced on the E-Series ExaScale (IPv6). Increased the
number of VLANs on ExaScale to 4094 (was 2094).
8.1.1.0 Introduced on the E-Series ExaScale (IPv4).
7.9.1.0 Introduced VRF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and added support for IPv6
address on the E-Series only.
terminal length
Configure the number of lines displayed on the terminal screen.
Z9500
Syntax
terminal length screen-length
Parameters
screen-length Enter a number of lines. Entering zero causes the terminal to
display without pausing. The range is from 0 to 512.
Defaults 24 lines
Command
Modes
• EXEC
• EXEC Privilege
170
Control and Monitoring