Command Line Reference Guide

Defaults 0 (Mapped using original packet flow-label value to the tunnel header flow-label
value.)
Command
Modes
INTERFACE TUNNEL (conf-if-tu)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
Usage
Information
This command is only valid for tunnel interfaces with an IPv6 outer header.
tunnel hop-limit
Configure the method to set the IPv4 time-to-live or the IPv6 hop limit value in the outer tunnel header.
Z9500
Syntax
tunnel hop—limit value
To restore the default tunnel hop-limit, use the no tunnel hop—limit
command.
Parameters
value Enter the hop limit (IPv6) or time-to-live (IPv4) to include in
the tunnel header. The range is from 0 to 255. The default is
64.
Defaults 64 (for IPv4 and IPv6)
Command
Modes
INTERFACE TUNNEL (conf-if-tu)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
Tunneling Commands
1651