Command Line Reference Guide

show logging kernellog
Display the kernel log for the specified hardware component.
Z9500
Syntax
show logging kernellog {cp | rp | linecard slot-id}
Parameters
cp Enter the keyword cp to display the kernel log for the
Control Processor on the switch.
rp Enter the keyword cp to display the kernel log for the Route
Processor on the switch.
linecard slot-id Enter the linecard slot-id parameters to specify the
line-card ports for which you want to display the kernel log.
The range of line-card slot IDs is from 0 to 2.
defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
Examples
Dell# show logging kernellog cp
00:00:02:326592:AHCI_P_SCTL(0x01ac) 0x00000300
00:00:02:326599:AHCI_P_SERR(0x01b0) 0x00000000
00:00:02:326605:AHCI_P_SACT(0x01b4) 0x00000000
00:00:02:655656:pca9555x3:pca9555_write: iic_smbus_write_byte
failed addr=0x20 cmd_reg=0x8 rv=5
00:00:02:656982:pca9555x3:pca9555_write: iic_smbus_write_byte
failed addr=0x20 cmd_reg=0x9 rv=5
00:00:02:659597:pca9555x3:pca9555_write: iic_smbus_write_byte
failed addr=0x20 cmd_reg=0xf rv=5
00:00:43:418634:PCI unit 0: Dev 0xb852, Rev 0x03, Chip
BCM56852_A2, Driver BCM56850_A0
00:00:43:418655:PCI unit 1: Dev 0xb852, Rev 0x03, Chip
BCM56852_A2, Driver BCM56850_A0
00:00:43:418671:PCI unit 2: Dev 0xb852, Rev 0x03, Chip
BCM56852_A2, Driver BCM56850_A0
1592
Simple Network Management Protocol (SNMP) and Syslog