Command Line Reference Guide

logging buffered — sets the logging buffered parameters.
logging console — sets the logging console parameters.
logging monitor — sets the logging parameters for the terminal connections.
logging source-interface
Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog
server.
Z9500
Syntax
logging source-interface interface
To disable this command and return to the default setting, use the no logging
source-interface command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16383.
• For the management interface on the RPM, enter the
keyword ManagementEthernet then the slot/port
information. The slot range is from 0 to 1 and the port
range is 0.
• For a Port Channel interface, enter the keywords port-
channel then a number. Tthe range is from 1 to 128.
• For a ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
1584
Simple Network Management Protocol (SNMP) and Syslog