Command Line Reference Guide

Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on S-Series Stacking.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage
Information
Dell Networking OS version 7.8.1.0 and later enhances the sflow implementation
for real time traffic analysis on the E-Series to provide extended gateway
information in cases where the destination IP addresses are learned by different
routing protocols and for cases where the destination is reachable over ECMP.
Related
Commands
show sflow — displays the sFlow configuration.
sflow polling-interval (Global)
Set the sFlow polling interval at a global level.
Z9500
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval
command.
Parameters
interval value Enter the interval value in seconds. The range is from 15 to
86400 seconds. The default is 20 seconds.
Defaults 20 seconds
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1540
sFlow