Command Line Reference Guide

Defaults 0 seconds
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
radius-server host
Configure a RADIUS server host.
Z9500
Syntax
radius-server host {hostname | ipv4-address | ipv6-address}
[auth-port port-number] [retransmit retries] [timeout seconds]
[key [encryption-type] key]
Parameters
hostname Enter the name of the RADIUS server host.
ipv4-address |
ipv6-address
Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X)
of the RADIUS server host.
auth-port port-
number
(OPTIONAL) Enter the keywords auth-port then a number
as the port number. The range is from zero (0) to 65535. The
default port-number is
1812.
retransmit
retries
(OPTIONAL) Enter the keyword retransmit then a number
as the number of attempts. This parameter overwrites the
radius-server retransmit command. The range is
from zero (0) to 100. The default is 3 attempts.
timeout
seconds
(OPTIONAL) Enter the keyword timeout then the seconds
the time interval the switch waits for a reply from the RADIUS
server. This parameter overwrites the
radius-server
timeout command. The range is from 0 to 1000. The
default is
5 seconds.
1476
Security