Command Line Reference Guide

• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
connected (OPTIONAL) Enter the keyword connected to filter only
directly connected routes.
ospf (OPTIONAL) Enter the keyword ospf to filter all OSPF routes.
static (OPTIONAL) Enter the keyword static to filter manually
configured routes.
Defaults Not configured.
Command
Modes
ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Related
Commands
ip prefix-list — enters PREFIX-LIST mode and configures a prefix list.
ip poison-reverse
Set the prefix of the RIP routing updates to the RIP infinity value.
Z9500
Syntax
ip poison-reverse
To disable poison reverse, use the no ip poison-reverse command.
Routing Information Protocol (RIP)
1389