Command Line Reference Guide

assigned to the queue under policy-map-input and
output QoS policy under policy-map-output context.
Defaults none
Command
Modes
CONFIGURATION (conf-policy-map-in and conf-policy-map-out)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage
Information
There are eight queues per interface on the Z9500. This command assigns a class
map or QoS policy to different queues.
Related
Commands
class-map — identifies the class map.
service-policy input — applies an input policy map to the selected interface.
service-policy output — applies an output policy map to the selected interface.
set
Mark outgoing traffic with a differentiated service code point (DSCP) or dot1p value.
Z9500
Syntax
set {ip-dscp value | mac-dot1p value}
Parameters
ip-dscp value (OPTIONAL) Enter the keywords ip-dscp then the IP DSCP
value. The range is from 0 to 63.
mac-dot1p
value
Enter the keywords mac-dot1p then the dot1p value. The
range is from 0 to 7.
Defaults none
1358
Quality of Service (QoS)