Command Line Reference Guide

Parameters
vlan vlan-id Enter the keyword vlan and then the ID of the VLAN. The
range is from 1 to 4094.
Defaults none
Command
Modes
CONF-CLASS-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage
Information
To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria.
Use this command to match an IP class-map against a single VLAN ID .
Related
Commands
class-map — identifies the class map.
match mac access-group
Configure a match criterion for a class map, based on the contents of the designated MAC ACL.
Z9500
Syntax
match mac access-group {mac-acl-name}
Parameters
mac-acl-name Enter a MAC ACL name. Its contents is used as the match
criteria in the class map.
Defaults none
Command
Modes
CLASS-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
Quality of Service (QoS)
1345