Command Line Reference Guide

Version Description
8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-
Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage
Information
NOTE: Per Port rate limit and rate police is supported for Layer 2 tagged and
untagged switched traffic and for Layer 3 traffic. Per VLAN rate limit and rate
police is supported on only tagged ports with Layer 2 switched traffic.
On one interface, you can configure the rate police command for a VLAN or
you can configure the
rate police command for an interface. For each physical
interface, you can configure three rate police commands specifying different
VLANS.
Related
Commands
rate-police — specifies traffic policing on the selected interface.
rate shape
Shape the traffic output on the selected interface.
Z9500
Syntax
rate shape [kbps] rate [burst-KB]
Parameters
kbps (Optional) Enter the keyword kbps to specify the rate limit in
kilobits per second (Kbps). The range is from 0 to 10000000.
The default granularity is Megabits per second (Mbps).
rate Enter the outgoing rate in multiples of 10 Mbps. The range is
from 0 to 40000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 0 to
10000. The default is 50.
Defaults Granularity for rate is Mbps unless you use the kbps option.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1334
Quality of Service (QoS)