Command Line Reference Guide

dot1p-priority
Assign a value to the IEEE 802.1p bits on the traffic this interface receives.
Z9500
Syntax
dot1p-priority priority-value
To delete the IEEE 802.1p configuration on the interface, use the no dot1p-
priority command.
Parameters
priority-value Enter a value from 0 to 7.
dot1p Queue Number
0 2
1 0
2 1
3 3
4 4
5 5
6 6
7 7
Defaults none
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
1332
Quality of Service (QoS)