Command Line Reference Guide

Command
Modes
REDIRECT-LIST
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series.
8.4.2.0 Introduced on the E-Series TeraScale.
seq
Configure a filter with an assigned sequence number for the redirect list.
Z9500
Syntax
seq sequence-number {permit | redirect {ip-address}} {ip-
protocol-number | protocol-type} {source mask | any | host ip-
address} {destination mask | any | host ip-address} [bit]
[operator]{source-port source-port| source-port-range start-
port - end-port} {destination-port destination-port|
destination-port-range start-port - end-port}
To delete a filter, use the no seq sequence-number command.
Parameters
sequence-
number
Enter a number from 1 to 65535.
permit Enter the keyword permit assign the sequence to the
permit list.
redirect Enter the keyword redirect to assign the sequence to the
redirect list.
ip-address Enter the IP address of the forwarding router.
ip-protocol-
number
Enter the keyword ip-protocol-number then the number
from 0 to 255 for the protocol identified in the IP protocol
header.
protocol-type Enter one of the following keywords as the protocol type:
• icmp for internet control message protocol
Policy-based Routing (PBR)
1283