Command Line Reference Guide

IPv6 PIM-Source Specific Mode Commands
The following IPv6 PIM-SSM commands are supported:
• ip pim ssm-range
• show ipv6 pim ssm-range
ipv6 pim ssm-range
Specify the SSM group range using an access list.
Z9500
Syntax
ipv6 pim ssm-range {access_list_name}
Parameters
access_list_na
me
Enter the name of the access list. Maximum 16 characters.
Defaults Default SSM range is 232/8 and ff3x/32
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
7.5.1.0 Introduced on the E-Series.
Usage
Information
After the SSM range is applied, the changes are applied internally without requiring
clearing of the TIB. The SSM ACL overrides the default range. To use the default
range while the SSM range is active, add the default range to the SSM ACL.
When the ACL rules change, the ACL manager and PIM modules apply the new
rules automatically.
When you remove the SSM ACL, the default range is restored. When you configure
the SSM range, the system supports SSM for the configured group range as well as
the default SSM range.
PIM-Source Specific Mode (PIM-SSM)
1275