Command Line Reference Guide

• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel
then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
hash-mask-
length
(OPTIONAL) Enter the hash mask length for RP selection.
The range is from 0 to 128. The default is 126.
priority (OPTIONAL) Enter the priority value for Bootstrap election
process. The range is from 0 to 255. The default is 0.
Defaults Refer to Parameters.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
7.4.1.0 Introduced
ipv6 pim dr-priority
Change the designated router (DR) priority for the IPv6 interface.
Z9500
Syntax
ipv6 pim dr-priority priority-value
To remove the DR priority value assigned, use the no ipv6 pim dr-priority
command.
Parameters
priority-value Enter a number. Preference is given to larger/higher number.
The range is from 0 to 4294967294. The default is 1.
Defaults 1
PIM-Sparse Mode (PIM-SM)
1259