Command Line Reference Guide

(*, 226.1.1.3), uptime 00:18:08, expires 00:00:52, RP
10.211.2.1, flags: SCJ
Incoming interface: TenGigabitEthernet 0/23, RPF neighbor
10.211.1.2
Outgoing interface list:
TenGigabitEthernet 1/0
(*, 226.1.1.4), uptime 00:18:08, expires 00:00:52, RP
10.211.2.1, flags: SCJ
Incoming interface: TenGigabitEthernet 0/23, RPF neighbor
10.211.1.2
Outgoing interface list:
TenGigabitEthernet 1/0
show running-config pim
Display the current configuration of PIM-SM snooping.
Z9500
Syntax
show running-config pim
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.4.1.0 Introduced on the E-Series ExaScale.
Example
Dell#show running-config pim
!
ip pim snooping enable
IPv6 PIM-Sparse Mode Commands
The following describes the IPv6 PIM-sparse mode (PIM-SM) commands.
1256
PIM-Sparse Mode (PIM-SM)