Command Line Reference Guide

To remove the access list, use the no ip pim join-filter ext-access-list
{in | out} command.
Parameters
ext-access-list Enter the name of an extended access list.
in Enter this keyword to apply the access list to inbound traffic.
out Enter this keyword to apply the access list to outbound
traffic.
Defaults none
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series for the port-channels and the S-
Series.
7.7.1.0 Introduced on the E-Series.
Example
Dell(conf)# ip access-list extended iptv-channels
Dell(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24
Dell(config-ext-nacl)# permit ip any 232.1.1.0/24
Dell(config-ext-nacl)# permit ip 100.1.1.0/16 any
Dell(config-if-te-1/1)# ip pim join-filter iptv-channels in
Dell(config-if-te-1/1)# ip pim join-filter iptv-channels out
Related
Commands
ip access-list extended — configure an access list based on IP addresses or
protocols.
1234
PIM-Sparse Mode (PIM-SM)