Command Line Reference Guide

ip pim dr-priority
Change the designated router (DR) priority for the interface.
Z9500
Syntax
ip pim dr-priority priority-value
To remove the DR priority value assigned, use the no ip pim dr-priority
command.
Parameters
priority-value Enter a number. Preference is given to larger/higher number.
The range is from 0 to 4294967294. The default is 1.
Defaults 1
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series on port-channels and the S-
Series.
Usage
Information
The router with the largest value assigned to an interface becomes the designated
router. If two interfaces contain the same designated router priority value, the
interface with the largest interface IP address becomes the designated router.
ip pim join-filter
Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command
prevents the PIM-SM router from creating state based on multicast source and/or group.
Z9500
Syntax
ip pim join-filter ext-access-list {in | out}
PIM-Sparse Mode (PIM-SM)
1233