Command Line Reference Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
passive-interface
Disable (suppress) sending routing updates on an interface.
Z9500
Syntax
passive—interface interface
To enable sending routing updates on an interface, use the no passive-
interface interface command.
Parameters
interface
Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
Defaults Enabled, that is sending of routing updates are enabled by default.
Command
Modes
ROUTER OSPF for OSPFv2
ROUTER OSPFv3 for OSPFv3
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
Open Shortest Path First (OSPFv2 and OSPFv3)
1211