Command Line Reference Guide

key-
encryption-
type
(OPTIONAL) Specifies if the key is encrypted.
Valid values: 0 (key is not encrypted) or 7 (key is encrypted).
key
Text string used in authentication.
The required lengths of a non-encrypted or encrypted key
are:
3DES - 48 or 96 hex digits; DES - 16 or 32 hex digits; AES-
CBC -32 or 64 hex digits for AES-128 and 48 or 96 hex digits
for AES-192.
authentication-
algorithm
Specifies the authentication algorithm to use for encryption.
Valid values are MD5 or SHA1.
key-
encryption-
type
(OPTIONAL) Specifies if the authentication key is encrypted.
Valid values: 0 (key is not encrypted) or 7 (key is encrypted).
key
Text string used in authentication.
For MD5 authentication, the key must be 32 hex digits (non-
encrypted) or 64 hex digits (encrypted).
For SHA-1 authentication, the key must be 40 hex digits
(non-encrypted) or 80 hex digits (encrypted).
Defaults Not configured.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the S4810 and Z9000.
8.4.2.0 Introduced on the E-Series TeraScale.
8.3.19.0 Introduced on the S4820T.
Usage
Information
Before you enable IPsec encryption on an OSPFv3 interface, first enable IPv6
unicast routing globally, configure an IPv6 address and enable OSPFv3 on the
interface, and assign the interface to an area.
1206
Open Shortest Path First (OSPFv2 and OSPFv3)