Command Line Reference Guide

Link State ID: 192.68.33.0
Advertising Router: 1.1.1.10
LS Seq Number: 0x80000016
Checksum: 0x1241
Length: 28
Network Mask: /26
TOS: 0 Metric: 1
Related
Commands
show ip ospf database — displays OSPF database information.
show ip ospf interface
Display the OSPF interfaces configured. If OSPF is not enabled on the switch, no output is generated.
Z9500
Syntax
show ip ospf process-id interface [interface]
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For the null interface, enter the keyword null then zero
(0).
• For loopback interfaces, enter the keyword loopback
then a number from 0 to 16383.
• For tunnel interfaces, enter the keyword tunnel then a
number from 0 to 16383.
• For Port Channel groups, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then the VLAN ID.
The range is from 1 to 4094.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1176
Open Shortest Path First (OSPFv2 and OSPFv3)